如何用万用表测量电容器的漏电大小? 电容器的漏电越小,其性能也越好。电容器漏电的大小可用万用表电阻档来测量,方法是用万用表最高电阻档(一般为RxlOk档),如图所示,用两根表笔分别接触电容器的两
CTZ3型片状微调电容器在电路中具有微细调节的功能,在高频电路中有着广泛的应用。CTZ3型片状微调电容器的外形如图所示。 图:CTZ3型片状微调电容器外形
使用电容器应注意以下几方面的问题: 1)电容器接在电路中,其两端的电压不应超过电容器本身的耐压值。使用电解电容器时,除了注意耐压值外,还要注意正、负极不能接错,否则电解电容器将被损坏,甚至发生
片状多层陶瓷电容器的介质材料 片状多层陶瓷电容器所采用的介质材料不同,其温度特性及工作温度范围也不相同。表给出了不同介质材料的工作温度范围及温度特性。 表:片状多层陶
CT1型瓷介电容器为圆片形结构、单向引出,适合印刷电路板安装,具有体积小、容量大的特点,适用于旁路、耦合及鉴频电路中,广泛用在仪器仪表及电子设备中。其外形如图一所示的特点,适用于旁路、耦合及鉴频电路中
瓷介电容器又称陶瓷电容器,它以陶瓷为介质,涂敷金属薄膜(一般为银)经高温烧结而形成电极,再在电极上焊上引出线,外表涂以保护磁漆,或用环氧树脂及酚醛树脂包封,即成为瓷介电容器。 作为瓷介电容器介
空气介质可变电容器是由一组固定不动的定片和可以旋转的一组动片构成的,动片和定片之间的绝缘介质为空气,如图一所示。由于转轴和动片相连,旋转转轴即可改变动片与定片之间的角度,从而可以改变电容量的大小。当动
纸介电容器用特制的电容器纸作为介质,铝箔或锡箔作为电极并卷绕成圆柱形,然后接出引线,再经过浸渍处理,用外壳封装或环氧树脂灌封而成。它的结构如图所示。 纸介电容器具有以下特点: 1由于介质厚度小(一
常用贴片铝电解电容器的外形尺寸见图。 图:贴片铝电解外形尺寸
CY3I型密封云母电容器采用金属外壳、全密封结构,具有电性能优良、损耗小、温度系数小、频率特性好、稳定性好等特点,适用于交、直流电路和脉动电路。其外形如图一所示,主要特性参数见表一。 图一 CY3