基于MSP430的MP3 源码+电路图+PCB+字库+SD卡
本文主要讲了几个烟雾报警器电路图,下面一起来学习一下
最简单音调电路图(一) 本次的音调控制电路,其中Ai为缓冲放大级,用以降低前级输出的负担。该电路的低频转折频率为30Hz,高频转折频率为1kHz,控制范围为±20dB.使用运算放大器不仅能设计出具有高
220V交流输入,一端经过一个4007半波整流,另一端经过一个10欧的电阻后,由10uF电容滤波。这个10欧的电阻用来做保护的,如果后面出现故障等导致过流,那么这个电阻将被烧断,从而避免引起更大的故障
348个实用电路图大全
ne555延时电路图(一) 用NE555开机延时输出高电平电路 开机延时输出高电平电路如上图所示。当开机接通电源后,由于电容C来不及充电,555时基电路的②、⑥脚处于高电平,③脚输出低电平。随着电容C
lcd1602显示电路图(一) 基于51单片机的lcd1602液晶显示屏连接电路图 lcd1602显示电路图(二) lcd1602液晶显示电路图 lcd1602工作原理是什么 线段的显示 点阵图形式液
本文主要讲了9014制作闪灯电路图,下面一起来学习一下
光电耦合器的工作原理 光电耦合器是一种把红外光发射器件和红外光接受器件以及信号处理电路等封装在同一管座内的器件。当输入电信号加到输入端发光器件LED上,LED发光,光接受器件接受光信号并转换成电信号,
mos管开关电路图(一) 图中电池的正电通过开关S1接到场效应管Q1的2脚源极,由于Q1是一个P沟道管,它的1脚栅极通过R20电阻提供一个正电位电压,所以不能通电,电压不能继续通过,3v稳压IC输入脚