SHT20温湿度芯片-i2c驱动,温度获取和计算。工程文件。可以直接进行编译,使用mcu为stm32f103vet6
STM32F030+SHT20温湿度模块,原理图,pcb,编写程序即可使用。
AM2320温湿度传感器51和arduino驱动代码32可参考移植
该文件是基于STC89C51的重力传感器和温湿度传感器代码的融合,由于数据多,使用串口打印数据的,温湿度传感器为DHT11,重力传感器ADXL345
本文采用了单总线数字温度、湿度传感器,应用单片机原理,LCD显示技术,实现了实验室多点温湿度参数的实时显示和超限报警系统,保障了实验室环境的可靠性,有效地提高了实验成功率。本系统还可以根据需要增加其他
本文设计了一个采用SHT10传感器的仓库温湿度监测系统,通过SHT10检测仓库的温度和湿度,如果检测到的温度、湿度值超过设定值时,由单片机AT89S55输出控制信号启动相应的加温和
研究了基于SHT11温湿度传感器和单片机技术的智能温湿度测量系统。系统使用SHT11温湿度传感器实时采集温湿度数据;同时采用AT 89s52单片机进行数据的存储和计算等处理;并通过扩展外围电路设计了一
系统基于SHT75温湿度传感器,利用EPA总线技术,实现有线网络的通信和对工业现场温度与湿度的监测,为用户提供一个适时性与便利性的远程监测系统。
下面介绍一下温湿度传感器SHT11的感测系统设计,希望对大家的学习有所帮助。
介绍了SHT11数字式温湿度传感器的工作原理;以某监测系统中的温湿度监测站为例,介绍了SHT11与单片机的接口电路、指令时序和温湿度测量过程。实际应用表明,该传感器具有测量精度高、响应速度快、抗干扰能