HP官方Vpro功能设置工具，iso直接可制作DOS启动盘。 The instructions of how to use the tool: Preparations: 1. Make an MS DOS bootable USB hard disk. 2. Unzip the zipped tool file and copy all onto the USB hard disk. 3. Remove Power-on password if there is any. 4. Suggest change the system boot-order to "USB Hard Disk FIRST" from F10 setup. Operation Steps: 1. Make sure power is off. 2. Attach the USB hard disk to the system. 3. Boot system to USB hard disk. The display will stop at VPro Uncommitted Descriptor Unlocked M anagement Engine disabled Flash Protection Override disabled **************************************** Do you want to enable or disable AMT now [Y, N]? 4. After you make a choice, the system will be configured and rebooted. At final, it will display either 1). AMT-Enabled VPro Enabled Descriptor Locked Management Engine enabled Flash Protection Override disabled or, 2). AMT-Disabled VPro Disabled Descriptor Locked Management Engine disabled Flash Protection Override disabled **Note: If to re-run the tool, simply either execute autoexec.bat, or reboot the system. anagement Engine disabled Flash Protection Override disabled **************************************** Do you want to enable or disable AMT now [Y, N]? 4. After you make a choice, the system will be configured and rebooted. At final, it will display either 1). AMT-Enabled VPro Enabled Descriptor Locked Management Engine enabled Flash Protection Override disabled or, 2). AMT-Disabled VPro Disabled Descriptor Locked Management Engine disabled Flash Protection Override disabled **Note: If to re-run the tool, simply either execute autoexec.bat, or reboot the system.